Forums › General Discussions › Spike 3.0.15
- This topic has 7 replies, 5 voices, and was last updated 7 years, 5 months ago by Jared.
- Andrew September 29, 2015 at 2:38 pm
We are releasing Spike version 3.0.15 today. There are two main additions.
We added the 5MHz RBW into the software for the SA44A and SA44B devices and we also added the ability to perform TG sweeps with the BB60A device (will require firmware update and TG44/TG124). To get the RBW to 5MHz for the SA44 devices, ensure your start frequency is greater than 200MHz and span is greater than 100MHz, and either increase RBW to 5MHz or enter it manually.
Download it at http://www.signalhound.com/Spike
If you have any questions, let us know.
AndyParticipantAndy September 30, 2015 at 3:01 pm
Many thanks for re-instating the 5 MHz RBW. It’s really handy for taking a quick look at what’s going on. The 250 KHz RBW caused the sweep to be too slow. Shame it’s limited to >200MHz, but it’s great anyway.
Justin CrooksModeratorJustin Crooks October 1, 2015 at 10:09 am
I’m glad you find it useful. I wish the 5 MHz RBW had better performance on the SA44B (DANL / spurious / amplitude accuracy), but I suppose for a quick, low res sweep it gets the job done.
The 200 MHz cutoff is necessary because of extremely poor spurious performance at lower frequencies.
пишет не может откалибровать
(Unable to connect to the internet or unable to find the necessary calibration file
on the internet during initialization. Ensure your PC has an internet connection
and try again. If it is connected to the internet and you are still receiving this
message, please contact Signal Hound.)
что делать, к интернету подключен?Andrew October 12, 2015 at 7:54 am
Please send me an email at firstname.lastname@example.org with this message and I can send you the calibration file and instructions.
JaredParticipantJared October 20, 2015 at 3:02 pm
When would you be able to look at adding a hide button/checkbox for the traces?
I dont want to delete the data, which OFF does, simply hide it from view to bring other waveforms to the front…
i.e. max hold on trace one, grab my rf burst, disable updating of max. max hold on trace three, grab different rf burst, disable updating of max, then use the ‘hide’ button to swap between them…
JaredAndrew October 21, 2015 at 9:15 am
Thanks for the reminder. This is one that is requested a lot. I’ll try to get this in the next release.
JaredParticipantJared October 27, 2015 at 3:54 pm
Just updated to v16 – Thanks for adding the HIDE!!
And the trigger is pretty cool – now I can see the burst tx channel power as well.
You must be logged in to reply to this topic.