Forums › SM Series Discussions › Some questions regarding SM200x and SM435x
- This topic has 0 replies, 1 voice, and was last updated 6 hours, 20 minutes ago by
andrewclegg.
- AuthorPosts
andrewcleggParticipantI am evaluating the SM200B, SM200C, SM435B, and SM435C as an upgrade from the BB60C units I have used with Spike over the past ~10 years. My primary use cases for upgrading are:
– Spectrum monitoring (including mobile/vehicle-based monitoring) at frequencies above 6 GHz;
– Acquiring short IQ captures of signals with bandwidths of 100 MHz or more (e.g., 5G NR, Wi-Fi, swept-frequency radar).After reviewing the datasheets and manuals, I have a few practical questions to help finalize my model selection:
– 160 MHz IQ Capture in Spike: I understand the SM200B/SM435B can capture up to 2 seconds of 160 MHz IQ into internal memory while the SM200C/SM435C can stream 160 MHz continuously over 10GbE. Does Spike natively support recording and saving 160 MHz IQ captures to disk on both the B and C models?
– Dropped-Sample Detection: During IQ streaming or segmented captures, how are dropped samples/packets flagged so corrupted captures can be identified?
– Thunderbolt-to-SFP+ Adapters on the C Models: Because the SM200C/SM435C lack the 2 GB internal DDR buffer found on the B models, how reliably do they perform for mobile/laptop use when connected via a Thunderbolt 3/4 (or USB4) to 10GbE SFP+ adapter rather than a native PCIe NIC? Are there specific Thunderbolt-to-SFP+ adapters you have validated for sustained 160 MHz streaming (or multi-second bursts) without packet loss?
– Internal GPSDO & Geolocation Logging: When an external GPS antenna is connected to discipline the internal OCXO, is the resulting NMEA location data (lat/lon/altitude) logged automatically alongside sweep or IQ recordings inside Spike? Also, does the GPS port supply bias voltage for active antennas?
– Real-World Overload Immunity vs. BB60C & ADC Overflow: Because the SM series specifies relative dynamic range (>110 dB) while the BB60C specifies an absolute range (-158 to +10 dBm), how do the SM units compare in practice when doing monitoring in environments with strong in-band or adjacent-band transmitters—particularly given the SM series’ sub-octave preselector filters and +20 dBm max input? Do the SM series units provide ADC overflow flags in Spike .shr recordings like the BB60C does? Is the ADC overflow flag noted in the metadata for Spike IQ captures?
– USB Cable Length on B Models: Assuming a high-quality locking USB 3.0 Type-B cable, what is the maximum recommended cable length for reliable performance with the SM200B/SM435B?
– Use of a USB 3 to USB C converter. If my laptop only has USB C ports, will the use of a USB 3 to USB C adapter negatively impact the performance of the SM200B/S435B?
Thank you in advance for your guidance.
- AuthorPosts
You must be logged in to reply to this topic.
