ASmilieParticipantASmilie August 27, 2021 at 9:59 am
I have a SM200B. I have some code that is executing the smGetSweep function in a timer. How would I go about changing parameters such as the start or center frequency? The documentation says “These settings do not take effect until the device is reconfigured for sweep measurement mode.” What do I have to do to accomplish device reconfiguration?
AndrewModeratorAndrew August 27, 2021 at 11:39 am
You will need to call smConfigure again for any new parameter changes to take effect. You can only have 1 sweep configuration active at a time. After each smConfigure, you should re-acquire the sweep parameters as well.
ASmilieParticipantASmilie August 28, 2021 at 12:26 pm
My name is Andrew as well!
You must be logged in to reply to this topic.