Cannot Dynamically Change Center Freq on BB60C from Gnu Radio Companion

[Gary]

I’m running the BB60C on a Dell laptop running Linux Mint Mate 19.2. (32 GB of RAM, i7 processor, 1 TB HDD, if that makes a difference). I’ve managed to load the drivers and Gnu Radio block.
I’ve managed to incorporate a BB60C as the source in a Gnu Radio Companion flowgraph using the IQ output. The flowgraph is just a basic spectrum analyzer that uses a “range” block to adjust the center frequency in 200 kHz increments. However, regardless of whether I use the slider or directly enter the frequency, the actual center frequency of the BB60C does not change. This flowgraph works fine with at least three, other SDRs (Nooelec RTL-SDR, Ettus Research USRP, HackRF One).

Any suggestions?

Thanks!

• This topic was modified 5 years, 1 month ago by Gary.

[Author]

Posts