Forums › SA Series Discussions › BB60C Calibration Files
- This topic has 2 replies, 2 voices, and was last updated 12 months ago by tlbui.
tlbuiParticipanttlbui June 6, 2022 at 9:43 pm
We try to use a third party software to connect to our BB60C analyzers. The 3rd party software requires the BB60C calibration files “.tep” and “.bin” files to run.
Could you please send us the calibration files for our BB60C; the serial numbers are:
Thank you in advance for your support.
AndrewModeratorAndrew June 7, 2022 at 8:34 am
The .tep and .bin files are specifically for the SA44/SA124 series devices, not the BB60. The BB60C does not place the calibration files on the PC at any point, and as a result the 3rd party software should not need any calibration files. I would contact the 3rd party software developer and ask them about this.
tlbuiParticipanttlbui June 8, 2022 at 2:35 am
Thank you Andrew.
Looking for further update from you, if any.
You must be logged in to reply to this topic.