Sorry for the tone of that message. Uncalled for, you guys are dancing as fast as you can. But, are there plans for this command for the next release? Or is it a total wish?

So I decided to look into this again, using Spike 3.8.2, and it still does not work. The response to chp:chp? in zero-span is the stale data from the swept acquisition. Updating on the screen, stale data using SCPI.

Once again, I would like to request this feature.

Just to make sure I understand:

If I have the measurement set up, can I get the result of the measurement out with SCPI?

Fully Automated setup may be asking too much, but you said:

“Once you have the configuration setup just the way you like, you can store all settings to a preset file that can be quickly loaded the next time you run the application.”

If that is the case, can I restore that state remotely?

If both answers are Yes I am good, I think.

Thanks!

Yes, more – if I save the configuration, can I call the file up remotely?

I can get the channel power number remotely as well?

I’ll be using either LabVIEW or python.

[Author]

Posts