- This topic has 1 reply, 2 voices, and was last updated 7 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
- Posts
Hi,
Why is “phase noise measurement mode” not available on BB60C?
Thanks a lot.Because of the BB60C architecture, its phase noise, especially at low frequencies (e.g. below 1 GHz) is not very good. So we decided to disable phase noise measurements rather than provide poor results.
The SM200A is recommended for phase noise measurements inside 100 kHz offset. The SA44B can make pretty good phase noise measurements as well, especially outside 100 kHz offset.
Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.