USB-TG44A, Device not found

Hi

I do have problem with Spike and my new USB-TG44A. It
fails with a “Device not found” error.
Load VCP is not checked.
I did install the Signalhound Ftdi driver but when I open the device manager driver version 2.12.24.0 is loaded which is newer than the one I get with Signalhound.
I did check the driveer with FTProg and get the following info:
ProductDesc: ‘SignalhoundTG’
Serial Number: 31510019

Do you have any solution to this problem?
I have used the FT232R device for many private projects and never had any problems with it.

Regards
Gudjon

Hello Gudjon,

If you want to control the TG directly, without an SA44/SA124, use the TGStandalone application found in the installation directory at C:\Program Files\Signal Hound\Spike\. Spike will only allow you to interface a TG after either a SA44 or SA124 is connected in the software.

Let me know if you have additional questions.

Regards,
Andrew

Hello Andrew

Thanks, that fixed the problem. Now I do have a nice sinewave.
Should have asked earlier 🙂

Regards
Gudjon

[Author]

Posts